LED Strip: 19.7 inches(with 7.9 inches Cable) / 50CM
Number of LED Lights: 18 leds
Led Type: 5050 SMD LED
Magnets: Black Sintered NdFeB Permanent Magnets
Extension Cable: 19.4 inches / 49.5cm
Power Connect Cable: SATA
Rated Voltage: DC 12V
The control box comes with adhesive foam tape on the bottom.
The power cable was a SATA to 12v cable instead
The strip has no adhesive at all but attaches to the case via quarter of an inch magnets that inside the led strip. These magnets are super strong, and do not sag or get pulled down by the weight of the cables. They are even strong enough to hold the extra cables beneath them.
The controller has 16 predetermined colors that are bright and distinguishable with 4 lighting effect, being strobe, flash, fade, and smoth.
1.Make sure that you have all the parts mentioned in the package list.
2.Connect the molex connector to PC power supply and other end to the IR control box.
3.Peel off the paper and stick the adhesive tape back in a proper position in the PC case.(Notice: IR receiver on the control box show be seen so that you can use remote controller change light colours.
4.Connect 2 led strip lights to the 4-pin ends with the extension cable.
5.Attach the strips well on the metal surface of the PC computer case.
2 x 30cm 18leds 5050 RGB LED Strip lighting
1 x SATA Connector Cable
1 x 24 key Remote Controller
1 x IR control box
1 x 4-pin extension cable
If any defective products, please feel free to contact us, LEDdess will offer you a replacement or refund you.
List Price: $17.56
Sale Price: $13.78